KWP2 support piece

KWW1 “foot” together with KWP2 support piece are used to strengthen subframe resistance to lateral forces and stiffen the system. They are used for greater outreaches and horizontal structure layout.

KWZ hanging element

KWZ hanging element is part of two systems – BSP KWRY and BSP KWH. In both cases KWZ element is inserted into KWRY profile. Two back walls of the element lock it in profiles cavity but enable installers to move it fairly easy along the profile.

KWRY 80 profile

KWRY80 is type of a Y profile used for hanging ACP or metal sheets. It is stiffer KWRY profile due to 80 mm long foot. Both shape of the profile and its dimensions result is much more resistant product that can be used for installing heavier panels and be used when horizontal forces are increased. … Czytaj więcej

KW4 PAS passive bracket

BSP KW4 PAS passive bracket has been designed with stricter regulations regarding thermal insulation parameter of exterior partitions in mind. Brackets have structural function and transfer vertical and horizontal loads to the main bearing structure of a building. KW4 PAS specially designed shape and materials used in production result in relatively high load capacity and … Czytaj więcej

KW1 PAS passive bracket

BSP passive brackets have been designed with stricter regulations regarding thermal insulation parameter of exterior partitions in mind. Brackets have structural function and transfer vertical and horizontal loads to the main bearing structure of a building. Specially designed shape and materials used in production result in relatively high load capacity and favourable thermal parameters at … Czytaj więcej

KWRY 50 profile

KWRY50 is type of a Y profile used for hanging ACP or metal sheets. It is cheaper KWRY profile due to 50 mm long foot. It can be used on objects that are subjected to lower loads. The middle part of the profile drains the water. Rain water that penetrates facade through vertical joints can … Czytaj więcej

KWW1 foot

KWW1 foot together with KWP2 element are a set used to improve brackets resistance to lateral forces and stiffen the assembly. It is sued for greater outreaches and horizontal substructure layout.

KWP1 extension piece

KWP1 extension piece is used to level the surface of the facade in case of unevennesses. Only one size of brackets can be used which has very positive impact on the logistics process. The main purpose of this element is to extend the outreach if even the longest BSP bracket is not sufficient.

KW1 bracket

KW1 bracket is a standard element and base for most of our systems. It has been designed in order to make installation easier as well as make the adjustment of the profiles possible in all three directions, what helps in dealing with unevennesses of concrete. Small “heel” at the side of brackets base increases its … Czytaj więcej